![]() ![]() Also remove outlet and switch covers and tape off all outlets to keep drywall cement out of them. It will be way less work to reinstall them than try to work around them. If you just jump in and start skim coating, you’ll probably end up cleaning drywall dust out of every nook and cranny of your house for a few months. C over the floors, furniture, appliances, etc, and seal off the room you’re working on to contain the dust to that room. Maryville TN House Tour – Completed Roomsĭrywall work can get really messy so take a little time to prep your space before you start mixing your drywall compound.If finishing glass mat or fiber-reinforced gypsum panels, check with the manufacturer for finishing instructions.ĭownload our quick-reference guide, Five Levels of Finish for Gypsum Board or watch the How-To video.Apply a skim coat of joint compound or material manufactured for this purpose to the entire surface.Cover fastener heads and accessories with three coats of joint compound.Add one coat of joint compound over interior angles.Add two coats of joint compound over all flat joints.All joints are then wiped with a joint knife, leaving a thin layer of compound over all joints and interior angles. In Level 5, all joints and interior angles have tape embedded in the joint compound. Level 5 provides a uniform surface and minimizes the possibility of joint photographing and/or fasteners showing through the final decoration. Gypsum board finishing Level 5 is typically specified in appearance areas where smooth wall designs are decorated with non-flat paints, glossy or decorative finishes, or dark/deep-tone paints or where critical lighting conditions occur. If finishing glass mat or fiber-reinforced gypsum panels, check with the manufacturer for finishing recommendations.Cover fastener heads and accessories with three layers of joint compound.After wiping interior angles with a joint knife, leaving a thin layer of compound, add one separate coat of joint compound over interior angles.After wiping joints with a joint knife, leaving a thin layer of compound over all joints, add two coats of joint compound over all flat joints.As in previous levels, all joints and interior angles have tape embedded in the joint compound. This level of finish is not recommended in spaces where non-flat or dark/deep-tone paints are going to be applied. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |